Oldham Engineering Ltd (OEL) has a wide range of manufacturing capabilities. This section briefly details the companies Fabrication extensive capabilities.
Our Platers and Coded Welders are qualified to the appropriate standards to do the task in hand.
Our processes and procedures are documented to ISO BSEN, AWS and ASME IX standards.
Where required, Oldham Engineering will undertake customer specific welding procedure qualification.
In brief, our capabilities include;
We process materials to BSEN 15614, AWS D1.1 and ASME IX standards, including;
Oldham Engineering also has a dedicated High Integrity Fabrication Division.
After the quality standard has been established, the most important step toward its achievement is the selection of the best process and procedures. By giving attention to the SIX Ps, weld quality will come about almost automatically, reducing subsequent inspection to a routine checking and policing activity. The SIX Ps are:The Oldham Engineering Ltd. 6 P's
Process Selection--The process must be right for the job.
Preparation--The joint configuration must be right and compatible with the welding process.
Procedures--To assure uniform results the procedures must be spelled out in detail and followed carefully during welding.
Pretesting--By full-scale mockups or simulated specimens the process and procedures are proved to give the desired standard of quality
Personnel--Qualified people must be assigned to the job.
All Oldham Engineering welding sets are calibrated to BS7570 (the Code of Practice for Validation of Welding Sets).
The objective of Non-Destructive Testing (NDT) is to seek out defects which are not permissible under the designated quality standard/specification.
Non-destructive testing, includes Visual, MPI, DPI, Radiography and Ultrasonic and is conducted at the clients / specification request.
Destructive testing, such as production weld test plates, is also conducted by Oldham Engineering upon client request.
Visual inspection will begin before the first arc is struck. Materials will be examined to see if they meet specifications for quality, type, size, cleanliness and freedom from defects
Foreign matter such as grease, paint, oil, oxide film and heavy scale, that could be detrimental to the weld is removed.
Alignment and the fit of parts and the fixtures will be inspected before welding commences. Joint preparation will also be checked as early inspection is a significant factor in weld quality.
Completed welds are visually inspected to ensure compliance with the appropriate client standards.
Oldham Engineering Weld Inspectors are PCN qualified. Visual Inspection standards include BSEN ISO17637
Magnetic Particle Inspection is used for the detection of surface and sub-surface defects in ferrous materials. It makes use of an externally applied magnetic field or electric current through the material and the principle that the magnetic flux will leave the part at the area of the flaw.
Dye Penetrant Inspection (DPI) is also called liquid penetrant inspection (LPI) and is used to locate surface-breaking defects.
DPI may be applied to all non-ferrous materials, but for inspection of ferrous components MPI is preferred for its subsurface detection capability.
DPI is used to detect casting and forging defects, cracks and leaks in new products as well as fatigue cracks on in-service components.
Radiography Inspection is used to detect internal flaws in welds. The radiographic film gives a permanent record of the results.
Ultrasonic Inspection is generally used for detecting defects in plates with a thickness of 10mm (3/8") and above. This is the preferred method for detecting planar defects.